Area 0 OSPF and RIP

From: rionaldi (rionaldi@cbn.net.id)
Date: Wed Jul 16 2003 - 14:51:52 GMT-3

• Next message: Willy Schoots: "RE: ISIS L2 routes getting to L1 table"
• Previous message: Lance_Knoblock@uccsn.nevada.edu: "FRTS Discard Eligible"
• Next in thread: Jung, Jin: "RE: Area 0 OSPF and RIP"
• Maybe reply: Jung, Jin: "RE: Area 0 OSPF and RIP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Let say 4 routers (ABCD) connected each other in hub and spoke manner.
Three router are in OSPF area 0 (A-B, A-C), AD is in RIP... The subnet
between two routing protocol is different. What the best way and how to make
route from OSPF injected into RIP due to RIP send and receive behaviour.

I knew several ways, I just wan to know the best way to do it between:
1. default route in RIP
2. tunneling (but I need to create 1 tunnel for each subnet that does not the
same as RIP subnet....)..
3. summarization..

Any Other way?

Regards,
rionaldi

• Next message: Willy Schoots: "RE: ISIS L2 routes getting to L1 table"
• Previous message: Lance_Knoblock@uccsn.nevada.edu: "FRTS Discard Eligible"
• Next in thread: Jung, Jin: "RE: Area 0 OSPF and RIP"
• Maybe reply: Jung, Jin: "RE: Area 0 OSPF and RIP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:41 GMT-3