From: Robert Laidlaw (laidlaw@consecro.com)
Date: Mon Jul 14 2003 - 12:54:46 GMT-3
Page 677 descibes the EIGRP neighboring process. To block eigrp packets,
block multicast address 224.0.0.10. This will stop neighbors from becoming
adjancent.
Rob
----- Original Message -----
From: <jsogla@comcast.net>
To: <ccielab@groupstudy.com>
Sent: Monday, July 14, 2003 10:49 AM
Subject: Alternative to passive-interface command?
> Hello all,
>
>
> I am looking /trying to figure this out:
>
> An alternative to using the passive-interface command is to use a more
> restrictive dialer list that denies EIGRP packets?
>
> Example:
>
> Pod4R2(config)#dialer-list 1 protocol ip ?
> deny Deny specified protocol
> list Add access list to dialer list
> permit Permit specified protocol
>
> Pod4R2(config)#dialer-list 1 protocol ip deny ?
> <cr>
>
> Dialer-list 1 protocol ip ????????
>
> This is in reference to:
>
> DDR - CCIE Practical Studies Vol. 1
>
> Chapter 7 Page 498 1st paragraph:
>
> Thank you for all your help,
>
> Jim S
>
>
> _______________________________________________________________________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:38 GMT-3