From: Scott Morris (swm@emanon.com)
Date: Fri Jun 20 2003 - 10:55:04 GMT-3
That would permit all of the /24's from 192.168.0.0 through
192.169.255.0 (less or equal to /24)... So that would be both even and
odd ones.
Good thought though!
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Cristian Henry H
Sent: Friday, June 20, 2003 9:47 AM
To: steve r
Cc: Brian Dennis; 'Nguyen Hoang Long'; 'Scott Morris'; ZaferP@koc.net;
ccielab@groupstudy.com; GokhanS@koc.net
Subject: Re: Prefix list question abouts odds and even routes
Mmm, let me see...
Could be ip prefix list even permit 192.168.0.0/23 le 24 ?
steve r ha escrito:
>
> Can prefix lists block all the odd or even routes like permiting only
> even subnets in 192.168.2-254.X by matching a bit in the prefix list ?
>
> Steve R
>
> ----- Original Message -----
> From: "Brian Dennis" <brian@labforge.com>
> To: "'Nguyen Hoang Long'" <ng-hlong@hn.vnn.vn>; "'Scott Morris'"
> <swm@emanon.com>; <ZaferP@koc.net>; <ccielab@groupstudy.com>
> Cc: <GokhanS@koc.net>
> Sent: Wednesday, June 18, 2003 1:15 AM
> Subject: RE: CBWFQ-FRTS-RSVP
>
> > Did you mean to send this to someone else? I was just commenting on
> > the default serial interface bandwidth.
> >
> > Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> >
> > -----Original Message-----
> > From: Nguyen Hoang Long [mailto:ng-hlong@hn.vnn.vn]
> > Sent: Tuesday, June 17, 2003 10:09 PM
> > To: Brian Dennis; 'Scott Morris'; ZaferP@koc.net;
> > ccielab@groupstudy.com
> > Cc: GokhanS@koc.net
> > Subject: Re: CBWFQ-FRTS-RSVP
> >
> > But Cisco does not say so, here the link:
> >
> > http://www.cisco.com/warp/public/105/cbwfq_frpvs.html#configurationn
> > otes
> >
> > <quote>
> > a.. When the bandwidth and priority commands calculate the total
> > amount of bandwidth available on an entity, the following guidelines
> > are invoked when
> > the entity is a shaped Frame Relay permanent virtual circuit (PVC):
> >
> > a.. If a Minimum Acceptable Committed Information Rate (minCIR) is
> > not configured, the CIR is divided by two.
> >
> > b.. If a minCIR is configured, the minCIR setting is used in the
> > calculation.
> >
> > c.. The full bandwidth from the above rate can be assigned to
> > bandwidth and priority classes. Thus, the max-reserved-bandwidth
> > command is not supported on Frame Relay PVCs, although you should
> > take care to ensure that
> > the amount of bandwidth configured is large enough to also
accommodate
> > Layer
> > 2 overhead. See What Bytes Are Counted by IP to ATM CoS Queueing?.
> >
> > a.. Avoid setting the CIR or minCIR at the access rate. Otherwise,
> > you may see output queues building up and causing big delays in
> > CBWFQ classes. The
> > reason is that the shape rate does not take into account the
overhead
> > bytes
> > of the flag and Cyclic Redundancy Check (CRC) fields, so shaping at
line
> > rate is actually oversubscribing and will cause interface
congestion.
> > There
> > really is no reason to shape at the access rate. You should always
> > traffic
> > shape at 95 percent of the access rate or, more generally, the
aggregate
> > shaped rate should always be 95 percent below the access rate.
> >
> > <quote>
> >
> > I have tested and it works as documented, do you have any comment
> > on that?
> >
> > Thanks,
> > Long
> >
> > ----- Original Message -----
> > From: "Brian Dennis" <brian@labforge.com>
> > To: "'Scott Morris'" <swm@emanon.com>; <ZaferP@koc.net>;
> > <ccielab@groupstudy.com>
> > Cc: <GokhanS@koc.net>
> > Sent: Wednesday, June 18, 2003 2:30 AM
> > Subject: RE: CBWFQ-FRTS-RSVP
> >
> >
> > > As a side note "low speed" physical interfaces default to 128k.
> > >
> > > Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> > >
> > > -----Original Message-----
> > > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > > Behalf
> > Of
> > > Scott Morris
> > > Sent: Tuesday, June 17, 2003 4:59 AM
> > > To: ZaferP@koc.net; ccielab@groupstudy.com
> > > Cc: GokhanS@koc.net
> > > Subject: RE: CBWFQ-FRTS-RSVP
> > >
> > > The default reservable bandwidth is 75% of the presumed link
> > bandwidth,
> > > whatever that may be. If you do a show interface, you can figure
> > > that part out. Physical serial interfaces, the default assumed
> > > bandwidth
> > is
> > > 1.544M. On sub-interfaces, it actually varies per IOS train on
> > > what
> > the
> > > default is, so just do a 'show interface' to see that.
> > >
> > > Scott
> > >
> > > -----Original Message-----
> > > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > > Behalf
> > Of
> > > ZaferP@koc.net
> > > Sent: Tuesday, June 17, 2003 4:07 AM
> > > To: ccielab@groupstudy.com
> > > Cc: GokhanS@koc.net
> > > Subject: CBWFQ-FRTS-RSVP
> > >
> > >
> > > Simple and straight question:
> > >
> > > When using FRTS with CBWFQ or RSVP, is the reservable bandwith is
> > >
> > > a) % 75 of CIR
> > > b) %75 of MINCIR
> > > c) CIR
> > > d) MINCIR
> > > e) None of the above
> > >
> > > Plese respond with an offical link if possible not just guessing.
> > >
> > > Regards
> > >
> > > Zafer
> > >
> > >
> > ____________________________________________________________________
> > ____
> > > _____
> > > ________________________________________________________________
> > >
> > > Bu e-posta mesaji kisiye ozel olup, gizli bilgiler iceriyor
> > > olabilir. Eger bu e-posta mesaji size yanlislikla ulasmissa,
> > > icerigini hic bir sekilde kullanmayiniz ve ekli dosyalari
> > > acmayiniz. Bu durumda lutfen e-posta mesajini kullaniciya hemen
> > > geri gonderiniz ve tum
> > kopyalarini
> > > mesaj kutunuzdan siliniz. Bu e-posta mesaji, hic bir sekilde,
> > > herhangi bir amac icin cogaltilamaz, yayinlanamaz ve para
> > > karsiligi satilamaz. Bu e-posta mesaji viruslere karsi anti-virus
> > > sistemleri tarafindan taranmistir. Ancak yollayici, bu e-posta
> > > mesajinin - virus koruma sistemleri ile kontrol ediliyor olsa bile
> > > - virus icermedigini garanti etmez ve meydana gelebilecek
> > > zararlardan dogacak hicbir sorumlulugu kabul etmez.
> > >
> > > This message is intended solely for the use of the individual or
> > entity
> > > to whom it is addressed , and may contain confidential
> > > information.
> > If
> > > you are not the intended recipient of this message or you receive
> > > this mail in error, you should refrain from making any use of the
> > > contents and from opening any attachment. In that case, please
> > > notify the
> > sender
> > > immediately and return the message to the sender, then, delete and
> > > destroy all copies. This e-mail message, could not be copied,
> > published
> > > or sold for any reason. This e-mail message has been swept by
> > anti-virus
> > > systems for the presence of computer viruses. In doing so,
> > > however, sender cannot warrant that virus or other forms of data
> > > corruption
> > may
> > > not be present and do not take any responsibility in any
> > > occurrence.
> > >
> > >
> > ____________________________________________________________________
> > ____
> > > _____
> > > ________________________________________________________________
> > >
> > >
> > >
> > ____________________________________________________________________
> > ___
> > > You are subscribed to the GroupStudy.com CCIE R&S Discussion
> > > Group.
> > >
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> > >
> > >
> > >
> > ____________________________________________________________________
> > ___
> > > You are subscribed to the GroupStudy.com CCIE R&S Discussion
> > > Group.
> > >
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> > >
> > >
> > >
> > ____________________________________________________________________
> > ___
> > > You are subscribed to the GroupStudy.com CCIE R&S Discussion
> > > Group.
> > >
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> > ____________________________________________________________________
> > ___
> > You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
> >
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________________
> _
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Cristian E. Henry REUNAE-mail: chenry@reuna.cl Fono: 56-2-3370336
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:11:03 GMT-3