From: Nishant Sharma \(IT\) (NishantS@daksh.com)
Date: Tue Jun 17 2003 - 03:56:10 GMT-3
Hi Group,
I want to make an operator level "en" password using which anyone should be
able to add "ip route" and delete these routes. I gave the following commands
on my catalyst 4006 (IOS ver - Version 12.1(13)EW
enable password level 2 cisco
privilege exec level 2 ip route
privilege exec level 2 no ip route
and after this I enter at user prompt using my NT domain username/password but
when I give level 2 command it gives the following error message -
Core-I-Switch>enable 2
% Error in authentication.
Please advise,
Regards,
Nishant
-----------------------------------------------------------------------------
--------------------------
"The information in this e-mail is the property of Daksh and may be
confidential and privileged. It is intended solely for the addressee.
Access to this email by anyone else is unauthorised.
If you are not the intended recipient, any disclosure, copying,
distribution or any action taken in reliance on it is prohibited and
may be unlawful. If you receive this message in error, please notify
the sender immediately and delete all copies of this message."
-----------------------------------------------------------------------------
-------------------------
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:59 GMT-3