From: Brian Dennis (brian@labforge.com)
Date: Sun Jun 08 2003 - 23:07:16 GMT-3
Under the interface use the "no peer neighbor-route" command. You should
also look into "why" the command is needed.
<CCO>
peer neighbor-route
To reenable the creation of peer neighbor routes on an interface once
this default behavior has been disabled, use the peer neighbor-route
interface configuration command. To disable the default behavior of
creating a neighbor route for the peer on a point-to-point interface,
use the no form of this command.
</CCO>
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yunjie Chen
Sent: Saturday, June 07, 2003 9:45 PM
To: CCIE Group
Subject: ISDN question
Hi,
I am facing a lab scenerio asking for
Configure the ISDN circuit such that the /32 bit host routes are not
created when the link is established..
what is the command to do so?
thanks a lot..
Yunjie
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:55 GMT-3