From: Jonathan V Hays (jhays@jtan.com)
Date: Sat May 31 2003 - 14:32:37 GMT-3
Thanks Brian.
The lesson learned for me is to step back and look at things on a higher
level. I was focusing on frame-relay solutions and rummaging around in
my head for another way to solve it with a frame-relay command.
-Jonathan
> -----Original Message-----
> From: Brian Dennis [mailto:brian@labforge.com]
> Sent: Saturday, May 31, 2003 1:15 PM
> To: 'Jonathan V Hays'; 'Ciscolab'; ccielab@groupstudy.com
> Subject: RE: Frame-relay Map
>
>
> Think about what the problem is. The problem is that the packet is
> routed to the interface and a layer 3 to layer 2 mapping
> doesn't exist.
> How do you solve it? You need to look into a solution that
> reroutes the
> packet so that it doesn't get routed directly to the
> interface but gets
> routed/forwarded to a remote end.
>
> Possible solutions: policy-routing, static route, dynamic route, etc.
>
> Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
>
> -----Original Message-----
> From: Jonathan V Hays [mailto:jhays@jtan.com]
> Sent: Saturday, May 31, 2003 9:48 AM
> To: 'Brian Dennis'; 'Ciscolab'; ccielab@groupstudy.com
> Subject: RE: Frame-relay Map
>
> I give up. ;-0
>
> How?
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > Behalf Of Brian Dennis
> > Sent: Saturday, May 31, 2003 11:22 AM
> > To: 'Tony Schaffran'; 'Ciscolab'; ccielab@groupstudy.com
> > Subject: RE: Frame-relay Map
> >
> >
> > Yes you can. There are other ways besides just using a map
> statement.
> >
> > Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > Behalf Of
> > Tony Schaffran
> > Sent: Saturday, May 31, 2003 5:55 AM
> > To: 'Ciscolab'; ccielab@groupstudy.com
> > Subject: RE: Frame-relay Map
> >
> > You cannot ping your local interface if you do not map it.
> >
> >
> > Tony Schaffran
> > Network Analyst
> > CCIE #11071
> > CCNP, CCNA, CCDA,
> > NNCDS, NNCSS, CNE, MCSE
> >
> www.cconlinelabs.com
> Your #1 choice for online Cisco rack rentals.
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of
> Ciscolab
> Sent: Friday, May 30, 2003 10:01 PM
> To: ccielab@groupstudy.com
> Subject: Frame-relay Map
>
> Hello, Group,
>
> When I map the frame-relay DLCI to IP address of remote mode, is there
> any
> requirement to map the local IP address to the DLCI also, thanks.
>
> !!!!!!!!!!!!!!!!Ciscolab
> !!!!!!!!!!!!!!!!ciscolab@vip.sina.com
> !!!!!!!!!!!!!!!!!!!!2003-05-31
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:51 GMT-3