From: Jonathan V Hays (jhays@jtan.com)
Date: Mon May 26 2003 - 21:47:56 GMT-3
I ended up doing "wr erase" and reconfiguring both routers and power
cycling everything.
Now ppp multilink with CHAP works is working correctly. The second line
comes up almost immediately after the first one. See below.
-Jonathan
r5#ping 10.1.1.6
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.6, timeout is 2 seconds:
..!!!
Success rate is 60 percent (3/5), round-trip min/avg/max = 36/46/64 ms
r5#
00:26:14: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
00:26:17: %LINK-3-UPDOWN: Interface Virtual-Access1, changed state to up
r5#
00:26:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1,
changed state to up
00:26:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Virtual-Access1, changed state to up
00:26:18: %LINK-3-UPDOWN: Interface BRI0:2, changed state to up
r5#
00:26:18: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to
4082222222 r6
r5#
00:26:21: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2,
changed state to up
r5#
00:26:24: %ISDN-6-CONNECT: Interface BRI0:2 is now connected to
4082222222 r6
r5#sh dialer
BRI0 - dialer type = ISDN
Dial String Successes Failures Last DNIS Last status
4082222222 3 0 00:00:34 successful
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0:1 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is multilink member
Dial reason: ip (s=10.1.1.5, d=10.1.1.6)
Connected to 4082222222 (r6)
BRI0:2 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is multilink member
Dial reason: Multilink bundle overloaded
Connected to 4082222222 (r6)
r5#
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:48 GMT-3