From: Lin Xiaodong (Linxiaodong@21Vianet.com)
Date: Mon May 26 2003 - 06:19:44 GMT-3
I've seen the state: up and normal from command "show atm ilmi-st", and
got
the prefix from the other end. but the remote end's ip add is shown
"peer
ip add 192.168.1.2".
why, what's matter? why is it not "172.16.1.2", maybe 172.16.1.2 is sec
address, is it possible? I still cannot ping the other end :(
----- Original Message -----
From: "Frank B" < frank@buff-net.com <mailto:frank@buff-net.com>>
To: "'Lin Xiaodong'" < Linxiaodong@21Vianet.com
<mailto:Linxiaodong@21Vianet.com>>
Cc: < ccielab@groupstudy.com <mailto:ccielab@groupstudy.com>>
Sent: Friday, May 23, 2003 4:58 PM
Subject: RE: ATM SVC
> Where you have the svc nsap below, ensure you place the nsap from the
> router at the other end of your svc.
>
> You can verify it's working by using show atm ilmi-status
>
> You should see ilmi state: UpandNormal
> And after the registered esi address it should say (confirmed)
>
> Frank
>
> -----Original Message-----
> From: nobody@groupstudy.com <mailto:nobody@groupstudy.com>
[mailto:nobody@groupstudy.com] On Behalf Of
> Lin Xiaodong
> Sent: Thursday, May 22, 2003 7:47 PM
> To: ccielab@groupstudy.com <mailto:ccielab@groupstudy.com>
> Subject: ATM SVC
>
> hi boddies,
> I config the atm svc as following but why i cannot always ping the
> remote end successfully ?
> maybe somewhere is wrong ? who can help me ? my config as follows
>
> int atm 2/0
> ip add 172.16.1.1 255.255.255.0
> atm esi-add xxxx.xxxx.xxxx.00
> pvc 0/16 ilmi
> !
> pvc 0/5 qusaal
> !
> atm ilmi-keepalive
> !
> atm arp-server self
> !
> svc nsap xx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.00
> proto ip 172.16.1.2 bro
> enc aal5snap
> !
>
> thanks in advance
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:48 GMT-3