From: Jung, Jin (jin.jung@lmco.com)
Date: Fri May 23 2003 - 16:29:10 GMT-3
Can u send me your config?
It could be a lots of things that could bring up BRI.
Unwantd LSAs. - route loop from different protocols
Peer neighbor - may nee no peer neighbor statenetb
CDP....
Send me your configs.
Jin jung...
-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: Friday, May 23, 2003 2:49 PM
To: Jung, Jin
Cc: ccielab@groupstudy.com
Subject: RE: ospf 's routing
Jin, thanks for your reply, I could see the route from C
now, but the bri could stop to dialer-up, Why? Even I set
the demand-circuit command on bri interface.
--- "Jung, Jin" <jin.jung@lmco.com> $B$+$i$N%a%C%;!<%8!'(J
> I normally setup virtual-link between two BRI
> routers.
> This should fix it.
>
> Jin jung...
>
> -----Original Message-----
> From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
> Sent: Friday, May 23, 2003 11:43 AM
> To: ccielab@groupstudy.com
> Subject: ospf 's routing
>
>
> hi, group
>
> The three routers, A--B--C are running ospf ,
> A,B was linked by bri ,
> belong area 1. B and C was line by serial port area
> 0.
> If I add command ip ospf demand-circuit on B's
> bri
> port, The C would not see the route to A or B's bri.
> If I cancel the
> demand-circult command, the C could see the IA route
> to A, B's bri port,
> Does is mornal? Or, May I have a way so that the C
> could see the bri's
> address while use the demand-circuit on B's bri
> port?
>
> Thanks alot
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! BB is Broadband by Yahoo! http://bb.yahoo.co.jp/
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:47 GMT-3