From: huang gang (bgv@ggv.com.cn)
Date: Thu May 22 2003 - 06:37:14 GMT-3
hi,
i think if you use the "broadcast" key words in frame relay map command,there is no need to config the neighbor .you only need to config the ip ospf priority to control the election of the DR.(precondition is that all router should connect the DR directly)
if i am wrong ,correct me pls!
huangg
----- Original Message -----
From: <Danny.Andaluz@triaton-na.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, May 22, 2003 8:51 AM
Subject: OSPF question
> Hello, Group. I've been trying to find an explanation to the following on
> CCO but cannot find one. Not even the OSFP design guide has it.
>
> I have a hub and spoke frame topology. The hub has a multipoint sub
> interface and the spokes are physical. The requirement is to not use IP
> OSPF network commands on the interface and to make sure the hub becomes the
> DR. Upon configuring a priority of 0 on the spokes, I could not configure
> neighbor statements under OSPF, which would satisfy the requirement of not
> using the ip ospf network command. it would take the neighbor statement,
> but it would not show up in the running config. Does anyone know why a
> priority of 0 does not let the neighbor statement take?
>
> Thanks,
> Danny
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:46 GMT-3