ospf point-to-multipoint

From: netchild ccie (netchildccie@hotmail.com)
Date: Wed May 21 2003 - 18:59:35 GMT-3

• Next message: Tim Fletcher: "Re: Help need about EIGRP distance"
• Previous message: Chris Jarosz: "Re: Wanted, 3 CCIE's in the Northeast and Texas"
• Next in thread: Brian Dennis: "RE: ospf point-to-multipoint"
• Maybe reply: Brian Dennis: "RE: ospf point-to-multipoint"
• Maybe reply: netchild ccie: "RE: ospf point-to-multipoint"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear Group,

I have three routers connected as hub-spoke topology. I'm runing ospf on
frame relay as multipoint interface on the hub router and normal physical
interface on the spoke routers.

I configured ospf as point-to-multipoint network. I have two questions
regarding this setup.

(1) Why I don't need to disable split-horizen on the hub serial interface ?
I need to do that when I configured RIP or EIGRP for the same setup.

(2) What is the use of /32 route that ospf inject to the route-table when I
use point-to-multipoint network since the next-hop is the IP address of the
hub router.

Regards,
NetChild,

• Next message: Tim Fletcher: "Re: Help need about EIGRP distance"
• Previous message: Chris Jarosz: "Re: Wanted, 3 CCIE's in the Northeast and Texas"
• Next in thread: Brian Dennis: "RE: ospf point-to-multipoint"
• Maybe reply: Brian Dennis: "RE: ospf point-to-multipoint"
• Maybe reply: netchild ccie: "RE: ospf point-to-multipoint"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:46 GMT-3