From: kym blair (kymblair@hotmail.com)
Date: Mon May 19 2003 - 18:39:08 GMT-3
Jim,
I agree, you must reload after removing frame relay subint.
Some interface commands (such as last hsrp) cannot be deleted. The solution
is "default interface serial 1/0" which blows away the entire interface.
Then paste back the portions of the interface you wanted to keep.
HTH, Kym
>From: "Brown, Jim" <Jim.Brown@caselogic.com>
>Reply-To: "Brown, Jim" <Jim.Brown@caselogic.com>
>To: "netchild ccie" <netchildccie@hotmail.com>, <ccielab@groupstudy.com>
>Subject: RE: change frame realy subinterface
>Date: Mon, 19 May 2003 13:49:39 -0600
>
>I think rebooting is the only way to change a subinterface. I could be
>wrong and I'm sure someone will be quick to correct me if I am.
>
>-----Original Message-----
>From: netchild ccie [mailto:netchildccie@hotmail.com]
>Sent: Monday, May 19, 2003 12:02 PM
>To: ccielab@groupstudy.com
>Subject: change frame realy subinterface
>
>
>Hi there,
>
>When I want to change the frame relay subinterface type from multipoint
>to
>point-to-point I got this message
>
>r2(config)#no int s 1/0.1
>% Not all config may be removed and may reappear after reactivating the
>sub-interface
>r2(config)#int s 1/0.1 point
>% Warning: cannot change link type
>
>I forced to reload the router. Is there another way to do that ?
>
>Regards,
>NetChild,
>
>_________________________________________________________________
>MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
>http://join.msn.com/?page=features/virus
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:45 GMT-3