From: dwight baldwin (dtstone01@yahoo.com)
Date: Fri May 16 2003 - 20:29:43 GMT-3
Hi All,
I'm having trouble getting dialer watch to work with
OSPF. Whenever I shutdown the primary path, the ISDN
dial comes up fine and with the "show dialer" command
the dialer reason states "Dial reason: Dialing on
watched route loss". However, the idle timer never
resets and when it expires, the ISN line goes down.
Anybody seen this problem or have any ideas about this
should be fixed? Also, isn't is best practice to use
this in conjunction with an ospf demand circut & to
deny ospf with the dialer-list command? Here is may
relavant config:
interface BRI0
ip address 133.1.50.5 255.255.255.252
encapsulation ppp
shutdown
dialer idle-timeout 30
dialer map ip 133.1.50.6 name R6-2503 broadcast
9082774366
dialer-group 1
isdn switch-type basic-ni
isdn spid1 90827716440101
no peer neighbor-route
no cdp enable
ppp authentication chap
dialer-list 1 protocol ip list 111
access-list 111 deny ospf any any
access-list 111 permit ip any any
Dwight
__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:44 GMT-3