RE: Question about dhcp

From: Georg Pauwen (pauwen@hotmail.com)
Date: Thu Apr 24 2003 - 14:11:08 GMT-3

Jonathan,

might seem simple to you, it apparently is not to him/her...

Hello,

the command is (under your DHCP pool config):

host address [mask | prefix-length]

Here is a link to the command syntax:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122tcr/122tip1r/p1ftdhcp.htm#1017851

Regards,

Georg

>From: "Jonathan V Hays" <jhays@jtan.com>
>Reply-To: "Jonathan V Hays" <jhays@jtan.com>
>To: <ccielab@groupstudy.com>
>CC: "'j'" <wkfrktpdy@hotmail.com>
>Subject: RE: Question about dhcp
>Date: Thu, 24 Apr 2003 09:49:14 -0400
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > Behalf Of j
> > Sent: Thursday, April 24, 2003 12:42 AM
> > To: ccielab@groupstudy.com
> > Subject: Question about dhcp
> >
> >
> > Is it possible to setup dhcp so that the same ip address
> > always gets assigned to the same dhcp client? (not using
> > local area mobility)
> >
> >
>
>Please search the documentation for answers to simple questions:
>
>http://www.cisco.com/univercd/home/home.htm
>
> Cisco IOS Release 12.1
>
> Cisco IOS Release 12.1 Configuration Guides and Command References
>
> P1R: Cisco IOS IP and IP Routing Command Reference, Release 12.1
>
> P1R: Part 1: IP Addressing and Services
>
> DHCP Commands
>
> host

This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:05 GMT-3