From: Brent Colwell (bcolwell@bellind.com)
Date: Wed Apr 23 2003 - 18:29:19 GMT-3
Jeongwoo,
You need Enterprise PLUS IOS to run IS-IS. You only have IP PLUS on your router right now.
Check out www.cisco.com\go\fn to find out what version of IOS supports specific features.
Regards,
Brent Colwell
-----Original Message-----
From: Jeongwoo Park [mailto:jpark@wams.com]
Sent: Wednesday, April 23, 2003 2:43 PM
To: 'ccielab@groupstudy.com'
Subject: Can't start ISIS
First time for me I practice isis in my router.
It doesn't seem to run isis.
r3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
r3(config)#router isis
r3(config)#n?
ncia netbios no ntp num-exp
r3(config)#n
r3(config)#clns router
^
% Invalid input detected at '^' marker.
r3(config)#
r5#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IS-M), Version 12.1(19), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Tue 04-Mar-03 13:08 by kellythw
Image text-base: 0x80008088, data-base: 0x80CF75E8
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
r5 uptime is 1 day, 23 hours, 38 minutes
System returned to ROM by power-on
System image file is "flash:c2600-is-mz.121-19.bin"
cisco 2610 (MPC860) processor (revision 0x203) with 26624K/6144K bytes of
memory.
Processor board ID JAD05400D0D (3721871652)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
What am I missing?
Thanks,
JP
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:03 GMT-3