From: Larson, Chris (CLarson@usaid.gov)
Date: Wed Apr 23 2003 - 10:14:17 GMT-3
Why do you say that? My understanding is that OSPF authentication can be per
interface or per area. If you have an area that spans multiple subnets,
then you can do OSPF on the links in that subnet and not the entire area. I
have done this in practice and have not had any troble using interface
authentication.
> -----Original Message-----
> From: Teck PhrEAk!! [SMTP:phreakinphunk@hotmail.com]
> Sent: Wednesday, April 23, 2003 12:00 AM
> To: jhaverkos@columbus.rr.com; jhays@jtan.com; ccielab@groupstudy.com
> Subject: RE: MD5, multipoint and OSPF
>
> "Note however that if interface authentication is used, all router
> interfaces in the same subnet must use the same type of authentication."
>
> This again suggests that OSPF authentication is area-wide authentication.
>
> cheers,
>
> sumit.
>
>
>
>
>
> >From: "Jerry Haverkos" <jhaverkos@columbus.rr.com>
> >Reply-To: "Jerry Haverkos" <jhaverkos@columbus.rr.com>
> >To: "Jonathan V Hays" <jhays@jtan.com>, <ccielab@groupstudy.com>
> >Subject: RE: MD5, multipoint and OSPF
> >Date: Tue, 22 Apr 2003 20:09:50 -0400
> >
> >Note however that if interface authentication is used, all router
> >interfaces
> >in the same subnet must use the same type of authentication.
> >
> >-----Original Message-----
> >From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> >Jonathan V Hays
> >Sent: Tuesday, April 22, 2003 4:54 PM
> >To: ccielab@groupstudy.com
> >Subject: RE: MD5, multipoint and OSPF
> >
> >
> >Page 17 of "Cisco OSPF Command and Configuration Handbook" by William
> >Parkhurst:
> >
> >"In Cisco IOS Software Release 12.X, the authentication used on an
> >interface can be different from the authentication enabled for an area.
> >When using Cisco IOS Software Release 12.X, the authentication method
> >used on different interfaces does not need to be the same.
> >Authentication can be turned off on selected interfaces using the
> >command 'ip ospf authentication null' (see Section 19-1)."
> >
> >HTH
> >
> > > -----Original Message-----
> > > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> > > Behalf Of Teck PhrEAk!!
> > > Sent: Tuesday, April 22, 2003 1:52 PM
> > > To: ng-hlong@hn.vnn.vn; ccielab@groupstudy.com
> > > Subject: Re: MD5, multipoint and OSPF
> > >
> > >
> > > hi Jenny,
> > >
> > > Remember,OSPF authentication is area-wide authentication........
> > >
> > > cheers,
> > >
> > > sumit.
> > >
> > >
> > >
> > >
> > > >From: "Nguyen Hoang Long" <ng-hlong@hn.vnn.vn>
> > > >Reply-To: "Nguyen Hoang Long" <ng-hlong@hn.vnn.vn>
> > > >To: <ccielab@groupstudy.com>
> > > >Subject: Re: MD5, multipoint and OSPF
> > > >Date: Tue, 22 Apr 2003 16:47:15 +0700
> > > >
> > > >Impossible, i think .
> > > >
> > > >
> > > >----- Original Message -----
> > > >From: "Jennifer Bellucci" <jennifer_bellucci@hotmail.com>
> > > >To: <ccielab@groupstudy.com>
> > > >Sent: Tuesday, April 22, 2003 2:41 PM
> > > >Subject: MD5, multipoint and OSPF
> > > >
> > > >
> > > > > Hiyah
> > > > >
> > > > > Say we have the net: r1-----r2-----r3. R2 has a multipoint FR int
> > > > > that connects to R1 / R3. All are in the same subnet. Is
> > > it possible
> > > > > to run
> > > >MD5
> > > > > authentication between just R2 and R1 and not between R2 / R3?
> > > > >
> > > > > I was under the illusion that when running OSPF you have
> > > to activate
> > > > > interfaces authentication as well, which means that it will peer
> > > > > with
> > > >the
> > > > > router config for the same auth type but not others, in
> > > the area. In
> > > > > the scenario, if its all in area 0, is it possible?
> > > > >
> > > > > I don't think so, but some of you might be able to bestow
> > > your wise
> > > >wisdom
> > > > > upon thee.
> > > > >
> > > > > Thanks
> > > > >
> > > > > Smile-=-
> > > > > Jennifer B"ll{cci 3
> > > > >
> > > > > Jennifer_bellucci@hotmail.com
> > >
> > >
> > > _________________________________________________________________
> > > Protect your PC - get McAfee.com VirusScan Online
> > > http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
>
> _________________________________________________________________
> The new MSN 8: advanced junk mail protection and 2 months FREE*
> http://join.msn.com/?page=features/junkmail
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:02 GMT-3