From: Georg Pauwen (pauwen@hotmail.com)
Date: Wed Apr 23 2003 - 04:45:09 GMT-3
Hello colleagues,
when I do a sh interfaces atm0/0, I get the following output; in the second
line, it says BW 256 Kbit and DLY 8000 usec.
Does anybody know where these values are pulled from ? This is an ADSL
connection, so maybe these values are pulled from the Service Provider ?
I have not configured any bandwidth statements in my config; could it be
that these are default values ?
ATM0/0 is up, line protocol is up
Hardware is DSLSAR (with Alcatel ADSL Module)
MTU 4470 bytes, sub MTU 4470, BW 256 Kbit, DLY 8000 usec,
reliability 255/255, txload 69/255, rxload 77/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5 AAL2, PVC mode
23 maximum active VCs, 256 VCs per VP, 1 current VCCs
VC idle disconnect time: 300 seconds
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 149
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 78000 bits/sec, 80 packets/sec
5 minute output rate 70000 bits/sec, 98 packets/sec
734284 packets input, 149320198 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
851590 packets output, 78919806 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
Thanks for your help in advance.
Regards,
Georg
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:02 GMT-3