From: Tim Fletcher (tim@fletchmail.net)
Date: Tue Apr 08 2003 - 11:32:01 GMT-3
Brian,
Try "caller-id alerting ring 2". If that doesn't work try setting it to 3.
If it does work, and you want an explanation let me know.
-Tim Fletcher #11406
At 08:44 PM 4/7/2003 -0500, Brian Sims wrote:
>Hi,
>
>I have the daily duties of implementing voice networks of about 40 phones per
>install. I am using a VG200 for the voice gateway. I have enabled caller-id
>on my voice ports and the local telephone carrier is sending caller-id across
>their analog line but I'm still not getting any caller information from an
>outside caller. Anybody have any ideas? I have attached a copy of the VG200
>configs to this email. Thanks in advance.
>
>Brian
>
>version 12.1
>no service single-slot-reload-enable
>no service pad
>service timestamps debug datetime msec localtime
>service timestamps log datetime msec localtime
>!
>hostname Flowers-ES-vg200
>!
>logging rate-limit console 10 except errors
>no logging console
>enable secret 5 $1$72BH$38oMBaKLMFhiNS2l6PEbW/
>!
>ip subnet-zero
>no ip finger
>!
>no mgcp timer receive-rtcp
>call rsvp-sync
>!
>!
>interface FastEthernet0/0
> ip address 10.195.0.10 255.255.0.0
> no ip route-cache
> no ip mroute-cache
> duplex auto
> speed auto
>!
>ip default-gateway 10.195.0.1
>ip classless
>ip route 0.0.0.0 0.0.0.0 10.195.0.1
>no ip http server
>!
>voice-port 1/0/0
>!
>voice-port 1/0/1
>!
>voice-port 1/1/0
> connection plar 25002
> description 260-1015
> caller-id enable
>!
>voice-port 1/1/1
> connection plar 25002
> description 260-1047
> caller-id enable
>!
>dial-peer voice 1 pots
> destination-pattern 9T
> port 1/1/0
>!
>dial-peer voice 2 pots
> destination-pattern 9T
> port 1/1/1
>!
>dial-peer voice 100 voip
> destination-pattern 250..
> session target ipv4:10.5.0.11
> dtmf-relay h245-alphanumeric
> codec g711ulaw
> no vad
>!
>line con 0
>!
>line aux 0
>line vty 0 4
> login
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:49 GMT-3