From: G. R. Correia (razzolini80@hotmail.com)
Date: Sun Mar 30 2003 - 12:40:38 GMT-3
try
(if- bri)# ip ospf cost 9999
hth
Guilherme
>From: tria_ka@gmx.net >Reply-To: tria_ka@gmx.net >To: "Fan Shan" >CC:
ccielab@groupstudy.com >Subject: Re: isdn up and down question in detail
>Date: Sun, 30 Mar 2003 08:00:01 +0200 (MEST) > >i had the same problem
for some weeks. >did u put the command > > no peer neighbor-route > >on
both sides ? >my link also flaps a long time, and any time later it
stops...?!?!? > >maybe as i see ur cfg is right. > >udo > > > > > Hello,
this is my isdn config: > > > > interface BRI0/0 > > ip address
133.1.35.5 255.255.255.252 > > encapsulation ppp > > ip ospf
demand-circuit > > dialer map ip 133.1.35.6 name rack01r3 broadcast
62194683 > > dialer load-threshold 128 either > > dialer-group 1 > > isdn
switch-type basic-net3 > > no peer neighbor-route > > no cdp enable > >
ppp authentication chap callin > > ppp chap hostname user01 > > ppp
multilink > > > > router ospf 100 > > router-id 133.1.5.5 > >
log-adjacency-changes > > area 0 authentication message-digest > > area 5
virtual-link 133.1.6.6 > > redistribute connected metric 100 subnets
route-map connect > > redistribute isis level-2 metric 100 subnets > >
network 133.1.5.5 0.0.0.0 area 0 > > network 133.1.35.5 0.0.0.0 area 0 >
> network 133.1.56.5 0.0.0.0 area 5 > > network 133.1.235.5 0.0.0.0 area
0 > > neighbor 133.1.235.3 > > neighbor 133.1.235.2 > > > > router isis >
> redistribute ospf 100 metric 30 metric-type external > > net
47.0001.0002.b910.cb60.00 > > > > This is the result of show dialer: > >
r5#show dialer > > > > BRI0/0 - dialer type = ISDN > > > > Dial String
Successes Failures Last DNIS Last status > > 62194683 478 47 00:00:20
successful > > 0 incoming call(s) have been screened. > > 0 incoming
call(s) rejected for callback. > > > > BRI0/0:1 - dialer type = ISDN > >
Idle timer (120 secs), Fast idle timer (20 secs) > > Wait for carrier (30
secs), Re-enable (15 secs) > > Dialer state is multilink member > > Dial
reason: ip (s=133.1.35.5, d=224.0.0.5) > > Connected to 62194683
(rack01r3) > > > > BRI0/0:2 - dialer type = ISDN > > Idle timer (120
secs), Fast idle timer (20 secs) > > Wait for carrier (30 secs),
Re-enable (15 secs) > > Dialer state is idle > > > > and this is routing
table : > > > > O E2 199.172.2.0/24 [110/100] via 133.1.235.2, 08:44:04,
Serial0/0.1 > > O E2 192.1.1.0/24 [110/20] via 133.1.235.2, 08:44:04,
Serial0/0.1 > > 133.1.0.0/16 is variably subnetted, 13 subnets, 3 masks >
> C 133.1.235.0/24 is directly connected, Serial0/0.1 > > i L1
133.1.4.0/24 [115/20] via 133.1.45.4, Serial0/0.2 > > C 133.1.5.0/24 is
directly connected, Loopback0 > > O 133.1.6.0/24 [110/65] via 133.1.56.6,
08:44:14, Serial0/1 > > O E2 133.1.1.0/24 [110/100] via 133.1.235.2,
08:44:04, Serial0/0.1 > > O 133.1.2.0/24 [110/65] via 133.1.235.2,
08:44:05, Serial0/0.1 > > O 133.1.3.0/24 [110/65] via 133.1.235.3,
08:44:05, Serial0/0.1 > > O IA 133.1.23.0/25 [110/74] via 133.1.235.2,
08:44:05, Serial0/0.1 > > [110/74] via 133.1.235.3, 08:44:05, Serial0/0.1
> > C 133.1.35.4/30 is directly connected, BRI0/0 > > C 133.1.45.0/24 is
directly connected, Serial0/0.2 > > C 133.1.55.0/24 is directly
connected, Ethernet0/0 > > C 133.1.56.0/24 is directly connected,
Serial0/1 > > O IA 133.1.66.0/24 [110/65] via 133.1.56.6, 08:44:09,
Serial0/1 > > 151.100.0.0/22 is subnetted, 1 subnets > > O E2
151.100.32.0 [110/100] via 133.1.235.2, 08:44:09, Serial0/0.1 > >
150.100.0.0/24 is subnetted, 2 subnets > > i L1 150.100.2.0 [115/20] via
133.1.45.4, Serial0/0.2 > > O E2 150.100.1.0 [110/100] via 133.1.235.2,
08:44:09, Serial0/0.1 > > O E2 199.172.4.0/24 [110/100] via 133.1.235.2,
08:44:09, Serial0/0 > > > > very stable,and no /32 mask ,as you can see >
> > > but when I use "debug ip ospf monitor", it shows continuous message
like > > this every 60 seconds: > > >09:35:39: OSPF: Syncing Routing
table with OSPF Database > > >09:35:39: OSPF: Completed Syncing and
runtime is 8 msec > > > > > >09:36:39: OSPF: Syncing Routing table with
OSPF Database > > >09:36:39: OSPF: Completed Syncing and runtime is 8
msec > > > > > >09:37:39: OSPF: Syncing Routing table with OSPF Database
> > >09:37:39: OSPF: Completed Syncing and runtime is 8 msec > > > > This
is my version: > > Version 12.1(5)T9 > > > > Now I am curious if there is
a bug in this version? I referenced a doc in > > cco: > >
>http://www.cisco.com/en/US/tech/tk826/tk365/technologies_tech_note09186a008009481b.shtml
> > But I didn't find any one of these reasons it lists . > > > >-- >+++
GMX - Mail, Messaging & more http://www.gmx.net +++ >Bitte ldcheln!
Fotogalerie online mit GMX ohne eigene Homepage!
------------------------------------------------------------------------
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:46 GMT-3