From: Xun Qu (xunq@hotmail.com)
Date: Fri Mar 28 2003 - 03:08:18 GMT-3
It may be needed:
neighbor 10.10.10.3 ebgp-multihop 255
because 10.10.10.3 is an EBGP peer.
cheers,
Xun
>From: "Voss, David" <dvoss@heidrick.com>
>Reply-To: "Voss, David" <dvoss@heidrick.com>
>To: "'ccielab@groupstudy.com'" <ccielab@groupstudy.com>
>Subject: Stumped on a Non-Exist Map
>Date: Thu, 27 Mar 2003 22:11:15 -0600
>
>I am doing an advertise-map non-exist-map to a neighbor. Regardless of
>what
>state it is in, the status is always stuck at "Uninitialized". I've
>cleared
>bgp and also rebooted. The route drops out just fine, but the
>non-exist-map
>never kicks in. Anybody know if it should be sitting in this state?
>
>show ip bgp nei
> Condition-map 100, Advertise-map 200, status: Uninitialized
>
>router bgp 4
> bgp router-id 4.4.4.4
> bgp cluster-id 3368601800
> bgp log-neighbor-changes
> network 200.200.200.0
> neighbor 10.10.10.3 remote-as 3
> neighbor 10.10.10.3 update-source Loopback100
> neighbor 10.10.10.3 advertise-map 200 non-exist-map 100
> neighbor 10.10.10.6 remote-as 6
> neighbor 10.10.10.6 ebgp-multihop 255
> neighbor 10.10.10.6 update-source Loopback100
>!
>R4#sh access-list 80
>Standard IP access list 80
> permit 100.100.100.0, wildcard bits 0.0.0.255 (2 matches) check=3
>R4#sh access-list 81
>Standard IP access list 81
> permit 200.200.200.0, wildcard bits 0.0.0.255 (3 matches) check=2
>route-map 100, permit, sequence 10
> Match clauses:
> ip address (access-lists): 80
> Set clauses:
> Policy routing matches: 0 packets, 0 bytes
>route-map 200, permit, sequence 10
> Match clauses:
> ip address (access-lists): 81
> Set clauses:
> Policy routing matches: 0 packets, 0 bytes
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:45 GMT-3