VoIP Dial-Peer

From: Voss, David (dvoss@heidrick.com)
Date: Sat Mar 22 2003 - 17:14:54 GMT-3

• Next message: Rick: "execellant ATM learning lab"
• Previous message: Fan Shan: "Access-list question"
• Next in thread: Jonathan V Hays: "RE: VoIP Dial-Peer"
• Maybe reply: Jonathan V Hays: "RE: VoIP Dial-Peer"
• Maybe reply: Franck ccie: "RE: VoIP Dial-Peer"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I've noticed that "destination-pattern" when placed under a dial-peer voice
pots statement does not hold a requirement for an exact match.

For example, a working scenario below. Even though my dial-peer
destination-pattern is 88888, if I dial 888889 from R7, it still works.

Can anyone else verify this?

Rack04R4
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0

dial-peer voice 4 voip
 destination-pattern 88888
 session target ipv4:1.1.1.4

Rack04R7
csim start 888889
csim: called number = 888889, loop count = 1 ping count = 0

csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0

• Next message: Rick: "execellant ATM learning lab"
• Previous message: Fan Shan: "Access-list question"
• Next in thread: Jonathan V Hays: "RE: VoIP Dial-Peer"
• Maybe reply: Jonathan V Hays: "RE: VoIP Dial-Peer"
• Maybe reply: Franck ccie: "RE: VoIP Dial-Peer"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:43 GMT-3