From: ccie2be (ccie2be@nyc.rr.com)
Date: Sat Mar 15 2003 - 22:20:43 GMT-3
Hi all,
I just finished reading for the nth time, the section on MVR (Multicast Vlan
Registration) in Chapter 18 of the 3550 Configuration Guide. I don't know if
it's just me or if that section just isn't all that clear but I really don't
get it.
I have a bunch of questions on it but my first question is this:
How important a topic is this? If I can't get this right will I lose all the
points for Multicast?
1) Regarding MVR itself, it seems that this feature creates a separate vlan
for multicast traffic and that access ports connected to hosts that want
multicast traffic "belong" to both their normal vlan and the multicast vlan.
But, how can that be if access ports can only belong to 1 vlan? (Ports that
carry the traffic of multiple vlans are trunks.)
2) Consider the situation where you have a multicast router connected via a
trunk to a Cat switch that doesn't have this feature. On the Cat switch there
are several vlans defined: vlan 5, 6, and 7 with hosts attached to each vlan.
Let's also say, CGMP is running between the router and the switch. Here's my
understanding (taken from the Beau Williamson book) of what happens when a
host wants to join a multicast group.
i) host sends an igmp report to the router (using the mac addr equivalent
of the ip mcast group)
ii) switch floods mcast frame to all ports regardless of vlan
iii) the router adds that m-group to its outgoing interface list if it's
not already there.
iv) router, using cgmp, informs switch to add the m-group to it's cam
table
v) the switch, using info from the cgmp message adds the host's port # to
the m-group entry
As a result, the cam table will now have 2 mac addresses associated with the
port:
a) the mac addr of the host hanging off the port used for regular unicast
traffic and
b) the mac addr of the ip multicast group so that mcast traffic goes to that
host
What's interesting in this process, is that all this activity seems to be
completely independent of vlans. If I'm understanding this correctly, unknown
multicast traffic is flooded to all ports - not just the ports in the same
vlan unlike broadcast traffic which only goes to those ports in the same
vlan.
So, here's what I can't figure out: How does the above process change with
MVR? And, what's the benefit of MVR over the above process?
I sure hope someone out there in group study can help me with this. I'd
really appreciate that.
Jim
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:40 GMT-3