From: FATHALLAH (sfathallah@mail.cbi.net.ma)
Date: Fri Mar 14 2003 - 13:56:28 GMT-3
There is two way for multilink setup : the standard PPP multilink . and
cisco proprity multilink witch you are using in your config (dialer
load-threshold 1 outbound ) this set the multilink without any condition
load is 1 )
Said FATHALLAH
-----Message d'origine-----
De : nobody@groupstudy.com [mailto:nobody@groupstudy.com]De la part de
Janto Cin
Envoyi : vendredi 14 mars 2003 09:02
@ : ccielab@groupstudy.com
Objet : isdn bri
Hi All,
I setup ISDN BRI between 2 routers.
Requirement is to make sure that both channels are being used when call is
placed.
My question is do we need configure ppp multilink because I didn't do that
but
both channels area being used?
TIA,
Janto
R5#sh run int b0/0
Building configuration...
Current configuration : 440 bytes
!
interface BRI0/0
ip address 150.10.65.1 255.255.255.252
encapsulation ppp
ip ospf message-digest-key 1 md5 cisco
ip ospf demand-circuit
dialer map ip 150.10.65.2 name R6 broadcast 8358661
dialer load-threshold 1 outbound
dialer-group 1
isdn switch-type basic-dms100
isdn spid1 0835866201 8358662
isdn spid2 0835866401 8358664
no peer neighbor-route
no cdp enable
ppp authentication chap callin
ppp chap hostname cisco5
end
R6#sh run int b3/0
Building configuration...
Current configuration:
!
interface BRI3/0
ip address 150.10.65.2 255.255.255.252
encapsulation ppp
ip ospf message-digest-key 1 md5 cisco
ip ospf demand-circuit
dialer map ip 150.10.65.1 name cisco5 broadcast
dialer-group 1
isdn switch-type basic-dms100
isdn spid1 0835866101 8358661
isdn spid2 0835866301 8358663
no peer neighbor-route
no cdp enable
ppp authentication chap
end
R5#sh dialer
BRI0/0 - dialer type = ISDN
Dial String Successes Failures Last DNIS Last status
8358661 12 1 00:01:02 successful
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0/0:1 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is data link layer up
Dial reason: ip (s=150.10.65.1, d=224.0.0.5)
Time until disconnect 55 secs
Connected to 8358661 (R6)
BRI0/0:2 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is data link layer up
Dial reason: Dialing on overload
Time until disconnect 57 secs
Connected to 8358661
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:39 GMT-3