From: c , (ccie1@hotmail.com)
Date: Fri Mar 07 2003 - 13:36:19 GMT-3
What about ip ospf network point-multipoint?
The quwstion didnt say you couldnt use those.
>From: "Tony Schaffran" <tschaffran@cconlinelabs.com>
>Reply-To: "Tony Schaffran" <tschaffran@cconlinelabs.com>
>To: "Scot Peter" <scotsman@rediffmail.com>, <ccielab@groupstudy.com>
>Subject: Re: OSPF on NBMA Networks
>Date: Thu, 6 Mar 2003 11:15:47 -0800
>
>This is a perfect example of not reading too deep into it. Keep it simple.
>If the scenario tells you "Don't configure Network type Broadcast or
>non-broadcast" and you can use neighbor statements, why not just use
>neighbor statements?
>
>Remember, you don't get extra points for creativity.
>
>
>
>Tony Schaffran
>Network Analyst
>CCIE #11071
>CCNP, CCNA, CCDA,
>NNCSS, NNCDS, CNE, MCSE
>
>www.cconlinelabs.com
>"Your #1 choice for Cisco rack rentals."
>
>
>----- Original Message -----
>From: "Tony Schaffran" <tschaffran@cconlinelabs.com>
>To: "Scot Peter" <scotsman@rediffmail.com>; <ccielab@groupstudy.com>
>Sent: Thursday, March 06, 2003 10:36 AM
>Subject: Re: OSPF on NBMA Networks
>
>
> > It sounds like you just need the neighbor statements.
> >
> >
> >
> > Tony Schaffran
> > Network Analyst
> > CCIE #11071
> > CCNP, CCNA, CCDA,
> > NNCSS, NNCDS, CNE, MCSE
> >
> > www.cconlinelabs.com
> > "Your #1 choice for Cisco rack rentals."
> >
> >
> > ----- Original Message -----
> > From: "Scot Peter" <scotsman@rediffmail.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Thursday, March 06, 2003 4:54 AM
> > Subject: OSPF on NBMA Networks
> >
> >
> > > Hello Group
> > >
> > > If we need to configure OSPF on a Multipoint interface with the
> > > following condition,
> > > - R1 should use Multipoint interfaces,
> > > - R2, R3 should not use subinterfaces,
> > > - All three routers should be in the same Network.
> > > - Don't configure Network type Broadcast or non-broadcast.
> > >
> > > R1
> > > / \
> > > R2 R3
> > >
> > > I am not sure about configuring "ip ospf network
> > > point-to-multipoint" (As the question mentions not to configure
> > > Non-broadcast) or do we need to configure using "neighbor"
> > > command? Please advice me on this.
> > >
> > > Regards
> > > Pet
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:34 GMT-3