From: Tony Schaffran (tschaffran@cconlinelabs.com)
Date: Thu Mar 06 2003 - 15:36:56 GMT-3
It sounds like you just need the neighbor statements.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCSS, NNCDS, CNE, MCSE
www.cconlinelabs.com
"Your #1 choice for Cisco rack rentals."
----- Original Message -----
From: "Scot Peter" <scotsman@rediffmail.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, March 06, 2003 4:54 AM
Subject: OSPF on NBMA Networks
> Hello Group
>
> If we need to configure OSPF on a Multipoint interface with the
> following condition,
> - R1 should use Multipoint interfaces,
> - R2, R3 should not use subinterfaces,
> - All three routers should be in the same Network.
> - Don't configure Network type Broadcast or non-broadcast.
>
> R1
> / \
> R2 R3
>
> I am not sure about configuring "ip ospf network
> point-to-multipoint" (As the question mentions not to configure
> Non-broadcast) or do we need to configure using "neighbor"
> command? Please advice me on this.
>
> Regards
> Pet
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:34 GMT-3