From: David Heaton (David.Heaton@citec.com.au)
Date: Wed Mar 05 2003 - 04:35:58 GMT-3
there is the "bridge x bitswap-layer3-addresses"
command
http://www.cisco.com/en/US/partner/tech/tk331/tk660/technologies_tech_note09186a008012811e.shtml
>>> <Sam.MicroGate@usa.telekom.de> 24/02/03 11:40:54 pm >>>
No it is all automatic. You only need the conversion when you configure
filters.
Sam
-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: Monday, February 24, 2003 4:12 AM
To: ccielab@groupstudy.com
Subject: bit ordering of MAC address
In the following network ,should I use some command to translate the
canonical to non-canonical ? Resume I the dls's peer setting is ok.
To0--Router--Eth0
or To0--Router--WAN--Router--Eth0
Thanks alot
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:32 GMT-3