From: OhioHondo (ohiohondo@columbus.rr.com)
Date: Sat Mar 01 2003 - 17:44:57 GMT-3
Is the OSPF cost of the Dialer higher than the ospf cost of the primary
circuit(s). If not, make the OSPF cost of the dialer MUCH higher that the
cost of the primary.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ccie candidate
Sent: Saturday, March 01, 2003 2:24 PM
To: ccielab@groupstudy.com
Subject: demand circuit with dialer profile
Hi everyone,
I'm trying to implement demand circuit with dialer profile. Everything works
fine but the isdn circuit keeps flapping every (120seconds -the default idle
timeout). If I implement the same config with legacy DDR(dialer map) demand
circuit (ip ospf demand-circuit) works OK. The question is to restore the
ospf routes if the LAN interface fails. Show dialer shows the the link
triggered by 224.0.0.5 (ospf hello) although the hello should be suppressed
in demand circuits.
But this does not happen with legacy DDR (dialer map). Any ideas ?
Thanks in advance ,
KAfkaf
Below is the topology
R5----ISDN----R3-----OSPF
| |
---------------------
---------------------------------
Do you Yahoo!?
Yahoo! Tax Center - forms, calculators, tips, and more
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:30 GMT-3