From: Scott M. Livingston (scottl@sprinthosting.net)
Date: Wed Feb 26 2003 - 10:32:41 GMT-3
Bryan Osoro posted on a board not too long ago....
"The trunking commands were only needed in the 2900XL and 3500XL series
switches, you do not need them on the 3550. You only need the switchport
voice vlan, and switchport access vlan # command."
Any comments?
Thank You,
scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Hunt Lee
Sent: Tuesday, February 25, 2003 11:33 PM
To: 'Cezar Fistik'
Cc: 'ccielab@groupstudy.com'
Subject: RE: voice vlans correct configuration
the 2nd one...
Voice VLAN only works on a Trunk port ;-)
Regards,
Hunt
-----Original Message-----
From: Cezar Fistik [mailto:cfistik@moldovacc.md]
Sent: Wednesday, 26 February 2003 12:57 PM
To: ccielab@groupstudy.com
Subject: voice vlans correct configuration
Hi group,
Could you please, share your ideas about the following configurations.
Just
assume that an ip phone is connected to int fast 0/10 and to the phone
is
connected a pc that is supposed to be in vlan 10
1.
mls qos
!
interface fastethernet 0/10
switchport mode access
switchport access vlan 10
switchport voice vlan 100
mls qos trust cos
2.
mls qos
!
interface fastethernet 0/10
switchport mode trunk
switchport trunk encapsulation dot1q
switchport voice vlan 100
mls qos trust cos
Which one do you think is correct? Or if they are both incorect I'll
appreciate any advice.
Thanks,
Cezar Fistik
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:36 GMT-3