RE: ??: RE: voice vlans correct configuration

From: Frank Maisano (FrankM@netarch.com)
Date: Wed Feb 26 2003 - 10:34:31 GMT-3


The use of the trunk mode is an older way of configuring Voice vlans on the
3524 or 3548 switches. The 3550 supports the newer way without using trunk.

The real answer on the test may be in the wording of the question or as
indicated below, another command on the same port that would impose some
limits on your choices. If there are no other restrictions, I would go with
the non-trunk mode since it is the newer way that came along with the
3550's.

-FM

-----Original Message-----
From: XiangQu
To: Hunt Lee; ccielab@groupstudy.com
Sent: 2/26/2003 2:36 AM
Subject: Re: ??: RE: voice vlans correct configuration

At 14:21 2003-2-26 +0800, zhaozx@DigitalChina.com wrote:
>mls qos
>!
>interface fastethernet 0/10
>switchport mode trunk
>awitchport trunk native vlan 10
>switchport trunk encapsulation dot1q
>switchport voice vlan 100
>mls qos trust cos
>
>
>the 2nd one...
>
>Voice VLAN only works on a Trunk port ;-)

3550 document says Voice Vlan Port can also be a " Protected port " ,
this
implies voice vlan port can be an Access Port, since you can not
configure
a port as Trunk port & Protected port simultaneously.

So, Both configurations are correct !

http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12112cea/3550s
cg/swvoip.htm

QuXJ

>Regards,
>Hunt
>
>
>-----Original Message-----
>From: Cezar Fistik [mailto:cfistik@moldovacc.md]
>Sent: Wednesday, 26 February 2003 12:57 PM
>To: ccielab@groupstudy.com
>Subject: voice vlans correct configuration
>
>
>Hi group,
>
>Could you please, share your ideas about the following configurations.
Just
>assume that an ip phone is connected to int fast 0/10 and to the phone
is
>connected a pc that is supposed to be in vlan 10
>
>1.
>mls qos
>!
>interface fastethernet 0/10
>switchport mode access
>switchport access vlan 10
>switchport voice vlan 100
>mls qos trust cos
>
>2.
>mls qos
>!
>interface fastethernet 0/10
>switchport mode trunk
>switchport trunk encapsulation dot1q
>switchport voice vlan 100
>mls qos trust cos
>
>Which one do you think is correct? Or if they are both incorect I'll
>appreciate any advice.
>
>Thanks,
>Cezar Fistik

Xiangjun Qu
_____________________________________________
Network Consulting Engineer CCIE#10593 (R&S)
Advanced Service, Cisco Systems (China).
Tel : (8610) 6526 7777 ext.5180
Mobile:(86) 13801211205
E-mail: xiangqu@cisco.com
_____________________________________________



This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:36 GMT-3