RE: Cat3550's command

From: David Terry (ETL) (David.Terry@etl.ericsson.se)
Date: Tue Feb 25 2003 - 08:20:47 GMT-3

• Next message: Tim O'Brien: "RE: ccie lab rescore"
• Previous message: kym blair: "Re: Documentation CD Outdated"
• Maybe in reply to: Tom Young: "Cat3550's command"
• Next in thread: matijevi@bellsouth.net: "Re: Cat3550's command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Sorry Tom didn't read your question fully I think you are after this as well......

ds1(config-if)#switchport mode dynamic ?
  auto Set trunking mode dynamic negotiation parameter to AUTO
  desirable Set trunking mode dynamic negotiation parameter to DESIRABLE

ds1(config-if)#switchport no
ds1(config-if)#switchport nonegotiate ?
  <cr>

thanks

David

-----Original Message-----
From: David Terry (ETL)
Sent: 25 February 2003 10:35
To: 'Tom Young'; ccielab@groupstudy.com
Subject: RE: Cat3550's command

Hi Tom,

The command you are after is

ds1(config-if)#switchport trunk encapsulation ?
  dot1q Interface uses only 802.1q trunking encapsulation when trunking
  isl Interface uses only ISL trunking encapsulation when trunking
  negotiate Device will negotiate trunking encapsulation with peer on
             interface

HTH

David

-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: 25 February 2003 09:54
To: ccielab@groupstudy.com
Subject: Cat3550's command

 Hello,group

 SOrry for a very simple question, what is the command for
set the trunk mode ( auto ,desirabel, nonegotiate...)on a
cat3550 switch, I use the ? make could find the hint in
the switch.

Thanks alot

• Next message: Tim O'Brien: "RE: ccie lab rescore"
• Previous message: kym blair: "Re: Documentation CD Outdated"
• Maybe in reply to: Tom Young: "Cat3550's command"
• Next in thread: matijevi@bellsouth.net: "Re: Cat3550's command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:34 GMT-3