From: ccie_studying (ccie_studying@hotmail.com)
Date: Mon Feb 24 2003 - 14:37:54 GMT-3
Would you try to put ip host g9r6 153.2.254.2 command in the new router
configuration file in the tftp server? And I assume 153.2.254.2 is the IP
address you are going to assign to your new router and g9r6 is the new
router name. Please let me know whether it's working.
Cheer!
----- Original Message -----
From: <trust.hogo@sarcom.com>
To: <Ted.Sanfilippo@PaeTec.com>; <FAliu@iteco.com>; <ccielab@groupstudy.com>
Sent: Thursday, February 13, 2003 2:26 PM
Subject: RE: Auto install
> Here is a sample config to get that done.
>
> Interface serial0
> no ip address
> encapsulation frame-relay
> no fair-queue
> no frame-relay inverse-arp
> frame-relay lmi-type cisco
>
> Interface serial0.9 point-to-point
> ip address 153.2.254.1 255.255.255.0
> ip helper-address 186.2.2.101 (tftp Server with configuration)
> ip directed broadcast
> frame-relay interface-dlci 209 protocol ip 153.2.254.2 (remote ip
address)
>
>
http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1831/products_conf
> iguration_guide_chapter09186a00800ca667.html
>
> You need to be logged in CCO to access this.
>
> Hope it helps
>
> Trust Hogo
> CCNP,CCDP
>
>
> -----Original Message-----
> From: Sanfilippo, Ted [mailto:Ted.Sanfilippo@PaeTec.com]
> Sent: Thursday, February 13, 2003 12:35 PM
> To: 'FAliu@iteco.com'; ccielab@groupstudy.com
> Subject: RE: Auto install
>
>
> Did you use the IP helper command?
>
> -----Original Message-----
> From: FAliu@iteco.com [mailto:FAliu@iteco.com]
> Sent: Thursday, February 13, 2003 11:40 AM
> To: ccielab@groupstudy.com
> Subject: Auto install
>
>
> Hi Guys,
>
> I tried doing autoinstall over frame relay . I specified the host specific
> file in my tftp server (g9r6-confg) and also the ip host name ip-address
in
> the network-confg file (both in my tftp server). Appropriate config was
> placed in the forwarding router staging router as cisco called it) but
each
> time the new router boots, it gives a DNS-Termination error and goes on to
> load network-confg, router-confg and cisconet-confg and after all that, it
> picks only the IP address and frame-relay encapsulation and does not pick
> other config . Can you enlighten me on what I could be doing wrong?
>
> rgds,
> Folorunso
> .
> .
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:33 GMT-3