From: Brian Dennis (brian@labforge.com)
Date: Thu Feb 20 2003 - 14:56:09 GMT-3
Take the standby command out of the serial and then it's just a normal
ISDN line. You can place a call by sending packets that match the dialer
list or you could use the isdn call command to trigger a manual call.
Rack4R4#isdn call interface bri 0/0 ?
WORD Dialing string
Rack4R4#
Brian Dennis, CCIE #2210 (R&S/ISP Dial/Security)
brian@labforge.com
http://www.labforge.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kim_W
Sent: Thursday, February 20, 2003 9:01 AM
To: ccielab@groupstudy.com
Subject: ISDN circuit test
Groups,
Currently I am using ISDN to back up a primay link failure with " backup
interface bri0" command under serial interface.
#sh int bri0
bri0 is standby mode, line protocol is down
I am looking for a way to test isdn line to see if it works without
bringing
down the serial line.
Any help !!!
Wol
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:31 GMT-3