From: Georg Pauwen (pauwen@hotmail.com)
Date: Tue Feb 18 2003 - 06:57:59 GMT-3
Hi Eric,
the 1900 series does not support 802.1Q, here is the excerpt from the Cisco
site:
The Catalyst 1900 runs two versions of images, namely the Standard and
Enterprise editions. Trunking is only supported on the Enterprise images,
and it only supports ISL encapsulation and does not support 802.1q. This
limits the capability of the Catalyst 1900 to form a trunk with other
Catalyst switches that can support ISL trunking. Furthermore, trunking can
only be configured on the two x 100 Mbps uplink ports on the Catalyst 1900.
These are the last two ports on the switch normally marked Ax and Bx. You
can configure up to 1005 VLANs on the Catalyst 1900 Enterprise image. The
Command Line Interface (CLI) (similar to the Cisco IOS. CLI) is only
available on the Enterprise image of the Catalyst 1900.
Regards,
Georg
>From: eric dong <dongmf@huawei.com>
>Reply-To: eric dong <dongmf@huawei.com>
>To: ccielab@groupstudy.com
>Subject: 802.1q and 1900
>Date: Tue, 18 Feb 2003 15:27:33 +0800
>
>Hi, all
>sorry for simple question, i am the poor man who don't have 3550, so i want
>use 2900xl and 1900 to test 802.1q. but i have not found where to config
>1900 trunk as dot1q.
>who can tell me that 1900 can trunk as 802.1q?
>
>eric d
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:26 GMT-3