From: Sanfilippo, Ted (Ted.Sanfilippo@PaeTec.com)
Date: Thu Feb 13 2003 - 14:34:32 GMT-3
Did you use the IP helper command?
-----Original Message-----
From: FAliu@iteco.com [mailto:FAliu@iteco.com]
Sent: Thursday, February 13, 2003 11:40 AM
To: ccielab@groupstudy.com
Subject: Auto install
Hi Guys,
I tried doing autoinstall over frame relay . I specified the host specific
file in my tftp server (g9r6-confg) and also the ip host name ip-address in
the network-confg file (both in my tftp server). Appropriate config was
placed in the forwarding router staging router as cisco called it) but each
time the new router boots, it gives a DNS-Termination error and goes on to
load network-confg, router-confg and cisconet-confg and after all that, it
picks only the IP address and frame-relay encapsulation and does not pick
other config .
Can you enlighten me on what I could be doing wrong?
rgds,
Folorunso
.
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:21 GMT-3