From: Ronald Fugate (RFugate@amdocs.com)
Date: Thu Feb 13 2003 - 10:41:53 GMT-3
If you running these on a 65xx
Just be careful not to exceed 16 standby groups.
The pfc will fill your logs with errors.
It will work, but drives harder on the cpu than it should.
Also, if you have to cold boot (power outage) then there can be problems with the standby groups initializing and stabilizing after negotiating.
You can add more than one vlan into a single standby group.
This will keep the standby groups to a minimum.
-----Original Message-----
From: Voss, David [mailto:dvoss@heidrick.com]
Sent: Wednesday, February 12, 2003 5:54 PM
To: 'CCIE FUN'
Cc: ccielab@groupstudy.com
Subject: RE: HSRP question
consider running multiple standby instances.
uschir04(config-if)#standby 1 ip ?
A.B.C.D Hot standby IP address
<cr>
uschir04(config-if)#standby 2 ip x.x.x.x
uschir04(config-if)#standby 3 ip x.x.x.x
-----Original Message-----
From: CCIE FUN [mailto:ccieexam2002@yahoo.com]
Sent: Wednesday, February 12, 2003 4:49 PM
To: ccielab@groupstudy.com
Subject: HSRP question
Hi all
I have two routers running HSRP for a network subnet
lets say for e.g 1.1.1.0/24 on E0 of both the routers.
now can i add secondary address to these routers on
Interface E0 and also run HSRP for these secondary
address.
I want to add about 10 secondary address.
how will the HSRP config be. Can i run HSRP for
multiple secondary addresses on these routers.
thanks
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:21 GMT-3