From: Hunt Lee (huntl@webcentral.com.au)
Date: Thu Feb 06 2003 - 04:00:14 GMT-3
Hi friends,
I have seen the below configs a few times...
dial-peer voice 3 voip
destination pattern 900
session target ipv4:129.9.1.1
preference 0
dial-peer voice 4 voip
destination pattern 900
session target ipv4:129.9.2.2
preference 1
Yet I don't understand what is it's purpose. There were 2 dial peers, with
different destination IPs, but with the same destination phone number?? So
is this saying from the local router, it will first try to dial to 129.9.1.1
(router B - FXS port1), and if it is busy, it then dials to (router B - FXS
port2)??
If this is the case, on Router B, would the following the correct?
dial-peer voice <1> pots
destination-pattern <900> <--- same local number on both FXS ports??
port <1/0/0>
dial-peer voice <2> pots
destination-pattern <900> <--- same local number on both FXS ports??
port <1/0/1>
Sorry if this is obvious, but I have no IP phone at hand, so i'm a bit
curious here.
Regards,
Lee
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:11 GMT-3