From: Brian McGahan (brian@cyscoexpert.com)
Date: Wed Feb 05 2003 - 12:35:29 GMT-3
Hunt,
You cannot change the distance of External EIGRP on a per prefix
basis. Therefore, either you must change the distance of the OSPF
prefix as you have done, or change the distance of all External EIGRP
prefixes as Jim has proposed.
For your DLSw+ question, yes you need a LLC2 mapping. Since
DLSw+ lite uses local acknowledgment, you must provide reliable
transport over the WAN. Frame-Relay by itself is not reliable,
therefore the extra LLC2 header must be added to ensure reliable
transport.
HTH
Brian McGahan, CCIE #8593
Director of Design and Implementation
brian@cyscoexpert.com
CyscoExpert Corporation
Internetwork Consulting & Training
Toll Free: 866.CyscoXP
Fax: 847.674.2625
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Hunt Lee
> Sent: Wednesday, February 05, 2003 7:19 AM
> To: ccielab@groupstudy.com
> Subject: CyscoExpert lab
>
> Hi friends,
>
> I have some questions about the configuration for Cyscoexpert Sample
lab.
>
> First: for question 2 under J
>
> 2. Double check R1, are you missing any routes?
>
> I got this to work by increasing the Admin Dist. of OSPF route at R4
from
> R3
>
> router ospf 1
> distance 180 195.1.3.3 0.0.0.0 1
>
> However, instead of doing this, if I tried to decrease the Admin Dist
of
> EIGRP route
> from R2 (via Tunnel). It doesn't work.
>
> I think it's because R2 actually got the route via OSPF as well, hence
> even now
> EIGRP has a lower Admin Dist than OSPF at R4, R2 would have no EIGRP
route
> (150.1.30.0/24) for distribute into R4.
>
> Am I right?
>
>
> Second: for question 3 under H.
>
> 3. Configure a DLSW+ session between R3 & R4 direct over the
Frame-relay
> network.
>
>
> I think it has been done by:
>
> dlsw local-peer peer-id 150.1.4.4
> dlsw remote-peer 0 frame-relay interface Serial0/0 403
> dlsw bridge-group 1
>
> Am I right?
>
> If so, is there any reason why I would need to use frame-relay map
llc2
> 403
> broadcast command? Is this command always required for DLSW Lite
config?
>
>
> Thanks so much for the help in advance,
>
> Cheers,
> Lee
>
> http://movies.yahoo.com.au - Yahoo! Movies
> - What's on at your local cinema?
> .
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:10 GMT-3