From: Lillemor Hamnqvist (lillemor@hamnqvist.org)
Date: Tue Feb 04 2003 - 22:23:15 GMT-3
Paul,
That's what I was looking for.
Thank you,
-----Original Message-----
From: paul.bosio@didata.com.au [mailto:paul.bosio@didata.com.au]
Sent: Tuesday, February 04, 2003 5:39 PM
To: Lillemor Hamnqvist
Subject: Re: OT: Voice compression
To get a better reading from the load on the serial interface use this
command...
int s0
load-interval 30
By default the load is over 5 minutes.
"Lillemor
Hamnqvist" To:
<ccielab@groupstudy.com>
<lillemor@hamnqvi cc:
st.org> Subject: OT: Voice
compression
Sent by:
nobody@groupstudy
.com
05/02/2003 07:04
AM
Please respond to
"Lillemor
Hamnqvist"
Hi,
I have a dedicated VoIP circuit, HDLC. What can I do to get the better
compression? I'm using g729, but it looks like each call takes about
30kb.(I
look at the load in the serial line). I would expect it to be lower. Is the
load number in 'show interface serial' accurate ? What is your experience ?
Thank you,
/lillemor
.
****************************************************************************
**
- NOTICE -
This message is confidential, and may contain proprietary or legally
privileged information. If you have received this email in error, please
notify the sender and delete it immediately.
Internet communications are not secure. You should scan this message and any
attachments for viruses. Under no circumstances do we accept liability for
any loss or damage which may result from your receipt of this message or any
attachments.
****************************************************************************
**
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:09 GMT-3