From: Ali Fahmi (afahmi@plasa.com)
Date: Thu Jan 16 2003 - 23:45:47 GMT-3
Did u put ip ospf priority 0 command?
On Thu, 16 Jan 2003 17:50:28 -0700
Jeffery S Kimes <kimes@us.ibm.com> wrote:
>I am working on a scenario that uses the OSPF NBMA
>model... Well, as I'm
>sure you are aware, you have to state what your neighbors
>are under the
>routing protocol.
>
>One of the routers that I have, after I put the neighbors
>in under the
>routing protocol, if I do a show running-config, they
>don't show up??? I
>thought that mebbe it was something to do with the
>verison of IOS, so I
>upgraded to 12.1.18. It didn't make a difference...
>
>So, is there something that I'm missing?
>
>Regards,
>
>Jeff Kimes
>Senior I/T Specialist
>I/T Consulting & Implementation Services
>kimes@us.ibm.com
>.
===========================================================================================
Meriahkan Hari Valentine Anda dan Ikuti Lomba Desain Kartu Eletronik dengan Tema Valentine
Ikuti Polling Pemilihan Pemenang Lomba Desain Kartu Elektronik Natal dan Tahun Baru 2003 di http://kartu.plasa.com/lomba
KSI PlasaCom - Reuni Alumni STTTelkom http://www.plasa.com/belajar/reuni.html
===========================================================================================
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:51 GMT-3