From: Barry Rowland (reachbarry@bigfoot.com)
Date: Thu Jan 16 2003 - 17:01:27 GMT-3
Yes, that works. But one of the routers has a dial tone without this
command, and yesterday
I went all day without this command on either router and had no issues.
Don't know why.
Thanks,
Barry
----- Original Message -----
From: "Brent Colwell" <bcolwell@bellind.com>
To: "Barry Rowland" <reachbarry@bigfoot.com>; <ccielab@groupstudy.com>
Sent: Thursday, January 16, 2003 1:59 PM
Subject: RE: UBR924 no dial tone.
> Barry, you have to put the command "cable-modem voip clock-internal" on
the cable 0 interface to get dial-tone. This link explains why.
>
>
http://www.cisco.com/en/US/products/hw/cable/ps2221/products_qanda_item09186
a008009441f.shtml#no_dial_tone
>
> Brent
>
> -----Original Message-----
> From: Barry Rowland [mailto:reachbarry@bigfoot.com]
> Sent: Thu 1/16/2003 1:00 PM
> To: ccielab@groupstudy.com
> Cc:
> Subject: OT: UBR924 no dial tone.
>
>
>
> Sorry for the OT, but I thought maybe someone else out there has run into
> this.
>
> I'm using 2 ubr924's, I picked up pretty cheap, to do Voip scenario's on
my
> home rack. The problem is
> after using them for a day and everything worked fine, exept as noted
below, I
> come in the next morning and cannot get a dial tone for any of the ports
on
> either unit.
>
> Debug indicates the ports do sense the off hook condition and come up with
a
> "tone", but you can't hear it on any of the phones. I have tried reboots,
both
> warm and power cycle, but still no dial tone. This is really strange, as
the
> same configs where working fine yesterday. I did have this problem with
one of
> the routers yesterday morning but after a few power cycles the ports came
up!
> I will be loading
> a 12.2 Enterprise image this evening to see if this helps.
>
>
> Thanks for any ideas!
>
> Barry
> .
> .
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:51 GMT-3