From: Joe Chang (changjoe@earthlink.net)
Date: Mon Jan 13 2003 - 14:23:58 GMT-3
Im reading a sample config for dialer watch:
http://www.cisco.com/warp/public/129/bri-backup-map-watch.html#dialerwatchope
ration
and it says:
"
a.. When a watched route is deleted, dialer watch checks for at least one
valid route for any of the IP addresses or networks being watched.
a.. If there is no valid route, the primary line is considered down and
unusable.
a.. Dialer watch then initiates the call, and the routers connect and
exchange routing information. All traffic for the remote network will now use
the backup link.
b.. If there is a valid route for at least one of the watched IP networks
defined and the route is pointing to an interface other than the backup
interface configured for dialer watch, the primary link is considered up and
dialer watch does not initiate the backup link.
"
So does that mean if I configure:
dialer watch-list 1 ip 10.10.10.0 255.255.255.0
dialer watch-list 1 ip 20.20.20.0 255.255.255.0
int bri0
dialer watch-group 1
Then if route 10.10.10.0/24 goes down but 20.20.20.0/24 stays up, then dialer
watch will NOT activate?
Thanks for your time,
Joe
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:48 GMT-3