From: Richard Young (cc_young@pacbell.net)
Date: Tue Jan 07 2003 - 04:24:11 GMT-3
I have found that this also happens to me. I have learned to unplug the
Cable and only use it when needed. I know of no workaround.
Joe wrote:
> 0x2102
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Tony Schaffran
> Sent: Thursday, January 02, 2003 11:22 PM
> To: 'Joe'
> Cc: ccielab@groupstudy.com
> Subject: RE: booting into rommon
>
> When you do a sh ver, what is the config register set to?
>
>
> Tony Schaffran
> Network Analyst
> CCNP, CCNA, CCDA,
> NNCDS, NNCSS, CNE, MCSE
>
> CCOnlineLabs.com
> http://www.cconlinelabs.com
>
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Joe
> Sent: Thursday, January 02, 2003 7:41 PM
> To: ccielab@groupstudy.com
> Subject: OT: booting into rommon
>
> I have noticed that if I leave a console cable connected into my 2509
> when I power it up, it frequently boots into ROMMON. The other end is
> connected to a Cisco headshell that is plugged into a PC that's powered
> off, just there in the event that I can't telnet in to the 2509. I
> don't believe there's a hardware problem since I can just type 'boot' at
> the ROMMON prompt and away it goes to a successful boot. Has anyone
> seen this kind of behavior?
>
> Joe
> .
> .
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:44 GMT-3