From: John Underhill (stepnwlf@magma.ca)
Date: Sun Jan 05 2003 - 11:35:06 GMT-3
Here's a basic config, dest patt is remote ph#, ip add is address of remote
router.. do the same on the other router.
dial-peer voice 2 voip
destination-pattern xxxx
session target ipv4:1.1.1.1
----- Original Message -----
From: "Sage Vadi" <sagevadi@yahoo.co.uk>
To: <ccielab@groupstudy.com>
Sent: Sunday, January 05, 2003 3:12 AM
Subject: VoIP: basic config help
> Hi all,
>
> Q) Is it possible to configure VoIP via ethernet
> ports?
>
> I ask this because the basic config examples on CCO do
> not seem to be via ethernet, but via frame.
>
> I have 2 routers, connected via ethernet. I can dial
> and here dial-tone, but the phones do not ring.
>
> Using FXS modules on a 2600.
>
> Cheers,
> Sage
>
> __________________________________________________
> Do You Yahoo!?
> Everything you'll ever need on one web page
> from News and Sport to Email and Music Charts
> http://uk.my.yahoo.com
> .
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:42 GMT-3