From: Naresh Chhetri (nareshc@hotmail.com)
Date: Sat Jan 04 2003 - 19:28:16 GMT-3
Kim,
i think u are missing the frame-relay dce command on the router which is
the dce.
----Original Message Follows---- From: "Yong Kim" Reply-To: "Yong Kim"
To: Subject: frame-relay question Date: Sat, 4 Jan 2003 13:33:02 -0800
Hello, I figured I would take down the hub router for a while but needed
to connect the satellite routers directly (using one serial cable).
However, I can't get it to work!? IOS is 12.1 (auto-sensing LMI). Is
there any way to configure frame-relay between two routers directly
without a hub router frame-relay switching in the middle or using
subinterface? R1: DCE side interface Serial0 ip address 192.168.2.1
255.255.255.0 encapsulation frame-relay clockrate 56000 frame-relay map
ip 192.168.2.2 102 R2: DTE side interface Serial0 ip address 192.168.2.2
255.255.255.0 encapsulation frame-relay frame-relay map ip 192.168.2.1
102 R1#sh ip interface brief Interface IP-Address OK? Method Status
Protocol Serial0 192.168.2.1 YES manual up down I would appreciate it if
some one can point out my mistake. Thank you, Yong Kim .
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:41 GMT-3