From: Tony Schaffran (tschaffran@cconlinelabs.com)
Date: Fri Jan 03 2003 - 01:21:47 GMT-3
When you do a sh ver, what is the config register set to?
Tony Schaffran
Network Analyst
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
CCOnlineLabs.com
http://www.cconlinelabs.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joe
Sent: Thursday, January 02, 2003 7:41 PM
To: ccielab@groupstudy.com
Subject: OT: booting into rommon
I have noticed that if I leave a console cable connected into my 2509
when I power it up, it frequently boots into ROMMON. The other end is
connected to a Cisco headshell that is plugged into a PC that's powered
off, just there in the event that I can't telnet in to the 2509. I
don't believe there's a hardware problem since I can just type 'boot' at
the ROMMON prompt and away it goes to a successful boot. Has anyone
seen this kind of behavior?
Joe
.
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:39 GMT-3