From: Ouellette, Tim (tim.ouellette@eds.com)
Date: Mon Dec 23 2002 - 03:24:33 GMT-3
Tony,
Good call on the subnets portion, I hadn't thought about that but he said he
could ping to them so I have to assume they're the correct number/mask
combination and in the same vlan. Again, only an assumption.
Tim
-----Original Message-----
From: Tony Schaffran [mailto:tschaffran@cconlinelabs.com]
Sent: Sunday, December 22, 2002 11:29 PM
To: 'Ouellette, Tim'; 'Lo Whitfield'
Subject: RE: Help with EIGRP routing problem.
I just had this problem. My Ethernets of each router were in different
subnets, but I forgot to put them in different vlans on the switch.
Tony Schaffran
Network Analyst
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
CCOnlineLabs.com
http://www.cconlinelabs.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ouellette, Tim
Sent: Sunday, December 22, 2002 8:03 PM
To: 'Lo Whitfield'
Cc: 'ccielab@groupstudy.com'
Subject: RE: Help with EIGRP routing problem.
Lo,
When the eigrp process sends out a Hello packet, it inserts it's IP
address
when it sends out the hello (source) . If your question, it looks like
both
r4 and r5 are on the 137.20.200.16/28 subnet and there shouldn't be a
problem with that. If you debug ip eigrp and possibly debug ip packet
so
see what ip address each side is using as the source of the eigrp hello.
Lemme know what happens.
Tim
-----Original Message-----
From: Lo Whitfield [mailto:lwhitfield01@earthlink.net]
Sent: Sunday, December 22, 2002 10:17 PM
To: ccielab@groupstudy.com
Subject: Help with EIGRP routing problem.
I keep getting the message "Neighbor 137.20.40.17 not on common subnet
for
Ethernet0" when on Router 5. How do I resolve this error message.
Router 4 is connect via of frame-Relay to R5. On Router 4, I have an
ethernet
with IP 137.20.40.17/28 and S0: 137.20.200.18/28. On router 5 I have
have
two
sub-interface s0.1:137.20.100.34/27 and s0.2:137.20.200.17/28. It's not
a
frame-Relay issue because I can ping between the routers. Once I added
all
the interfaces to EIGRP process, the error message above appeared. What
causes this message and how can I fix it? Thanks in advance for your
help
Lo
.
.
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:51 GMT-3