From: BIGB97750@aol.com
Date: Fri Dec 20 2002 - 17:19:22 GMT-3
Scott,
This is not terribly difficult. You should configure the hub router with the dialer map statements, just do not broadcast the dial string. If you are using a simulator that needs to spids programmed you should use the dial statement for both.
To bring up the second b channel just use ppp multilink. Remember that the second channel with not become active if there is not sufficient traffic across the link. To test this you can do extended ping increasing the packet sizes. I would not worry about over configuring anything just make sure that you provide what they are looking for on the question.
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:50 GMT-3