From: Nathan Chessin (nchessin@cisco.com)
Date: Mon Dec 09 2002 - 18:30:05 GMT-3
This is true, but the syntax is incorrect.
There should be a wildcard mask on the distance command as in the following:
distance 90 10.1.0.1 0.0.0.0 50 (to match the exact IP Address)
Also, note that for OSPF, the address to match is the OSPF RID, where in
other routing protocols such as RIP or EIGRP, the address to match is the
link connected to that neighbor.
Nate
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Surjamukhi Chatterjea
> Sent: Monday, December 09, 2002 11:04 AM
> To: 'Cristian Henry H'; 'Prio Utomo'
> Cc: ccielab@groupstudy.com
> Subject: RE: Distance Question
>
>
> Somebody correct me if I am wrong on the syntax, but I think one neat
> feature
> is that the distance command can be applied to specific
> routes using ACLs:
>
> RouterA# router ospf 1
> distance 95 10.1.0.1 255.255.255.0 50
>
> access-list 50 perm 172.168.3.0 0.0.0.255
>
> On RouterA, the route for network 192.168.3.0 announced by
> 10.1.0.1 will turn up with AD 95.
>
> Best
> Surja
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Cristian Henry H
> Sent: Monday, December 09, 2002 5:57 AM
> To: Prio Utomo
> Cc: ccielab@groupstudy.com
> Subject: Re: Distance Question
>
>
> Just in the router
>
> Prio Utomo wrote:
> >
> > Dear All,
> >
> > What is the scope of AD changes made by distance command?
> does it change
> the
> > whole routing domain AD or just in the router?
> >
> > Regards,
> > Prio
> > .
> --
> Cristian E. Henry
> REUNA
>
> E-mail: chenry@reuna.cl
> Fono: 56-2-3370336
> .
> .
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:43 GMT-3