Re:eigrp neighbor command

From: eward15@juno.com
Date: Mon Dec 09 2002 - 21:52:52 GMT-3

• Next message: Michael Todd: "Re: Where can I find docs about Qos ?"
• Previous message: Chuck Church: "Re: Where can I find docs about Qos ?"
• Maybe in reply to: Ram Shummoogum: "eigrp neighbor command"
• Next in thread: Ram Shummoogum: "Re:eigrp neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I believe the neighbor command is used to send routing annoucements as unicast packets instead of multicast or broadcast cast packets. For instance, there may be 5 routers on a segment but only two of them are using the same routing protocol. Instead of needlessly sending updates to the other routers, you could use a passive-interface to block the broadcasts/multicasts on the interface and instead send a directed unicast. Someone please correct me if I am wrong.

Eugene Ward

• Next message: Michael Todd: "Re: Where can I find docs about Qos ?"
• Previous message: Chuck Church: "Re: Where can I find docs about Qos ?"
• Maybe in reply to: Ram Shummoogum: "eigrp neighbor command"
• Next in thread: Ram Shummoogum: "Re:eigrp neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:41 GMT-3