ICANREACH Mac-Exclusive

From: Young K. Bae (ybae@cisco.com)
Date: Fri Dec 06 2002 - 18:29:04 GMT-3

Next message: MADMAN: "Re: Show IP BGP neighbors"
Previous message: Jay Greenberg: "Re: ospf demand-circuit"
Next in thread: Sam.MicroGate@usa.telekom.de: "RE: ICANREACH Mac-Exclusive"
Maybe reply: Sam.MicroGate@usa.telekom.de: "RE: ICANREACH Mac-Exclusive"
Maybe reply: Joe Chang: "Re: ICANREACH Mac-Exclusive"
Maybe reply: Mahmud, Yasser: "RE: ICANREACH Mac-Exclusive"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

A quick sanity check on the ICANREACH statement:

dlsw icanreach mac-exclusive
dlsw icanreach mac-address 4000.3745.0000 mask ffff.ffff.ffff

1. According to the documentation, there is an 'implicit deny-all' within
the ICANREACH <mac-address> statement. If that's true, why would one need
to configure 'dlsw icanreach mac-exclusive'?

2. Considering above configuration, if the device (MAC 4000.3745.0000)
resides on an Ethernet segment, the true MAC address of the device is
0200.ECA2.0000, correct?

TIA,
.

Next message: MADMAN: "Re: Show IP BGP neighbors"
Previous message: Jay Greenberg: "Re: ospf demand-circuit"
Next in thread: Sam.MicroGate@usa.telekom.de: "RE: ICANREACH Mac-Exclusive"
Maybe reply: Sam.MicroGate@usa.telekom.de: "RE: ICANREACH Mac-Exclusive"
Maybe reply: Joe Chang: "Re: ICANREACH Mac-Exclusive"
Maybe reply: Mahmud, Yasser: "RE: ICANREACH Mac-Exclusive"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:40 GMT-3